HomeForumsTechnical – GeneralBody & Paintvb – vl A pillar cavity?

This topic contains 3 replies, has 3 voices, and was last updated by Profile photo of VRSenator065 VRSenator065 5 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #8195
    Profile photo of SouthRidge
    SouthRidge
    Participant
    Member since: May 1, 2015
    Posts: 44

    Does anyone know were the cavity of the a pillar leads? Im currently plumbing up the drain pipes for my sunroof, so they’ll need to exit the car or drain into a factory drain channel.

    Any help would be great.

    #8456
    Profile photo of ajvx01
    ajvx01
    Participant
    Member since: March 2, 2015
    Posts: 102
    Supporter

    I’d like to know the answer also?

    #8731
    Profile photo of SouthRidge
    SouthRidge
    Participant
    Member since: May 1, 2015
    Posts: 44

    Hey i found that upon closer inspection there is actually two layers (inner and outer). If viewed on the correct angle you can see another cutout offset a couple inch’s to the front. This second outer cavity runs down to the kick panel area on the inside. – Solved.

    The inner layer seems to go no were to a dead end.

    Hope this helps others.

    #8732
    Profile photo of VRSenator065
    VRSenator065
    Participant
    • Adelaide SA
    • VR Senator LSx454 1960 Kombi (project) 1921 Nash Hot Rod (future project)

    • View build HERE
    Member since: February 17, 2015
    Posts: 5 716
    Supporter

    Nice work, if you can post a pic of what you did :)

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.